Guides · Marmi di Carrara · 1956
How to remove a stain from marble
Updated · By Marmi di Carrara srl
Stain or etch?
Tell the two cases apart before acting. A stain is colour that has entered the stone (coffee, wine, oil, rust, ink) and shows on any finish. An etch is a dull mark with no colour, left by an acid that has dissolved the calcium carbonate: lemon, vinegar, tomato, limescale remover. A poultice does not remove an etch: see the etching guide.
Why marble stains
Carrara marble is a crystalline limestone that is naturally porous: if a liquid stays on the surface, it goes in. A water- and oil-repellent protective treatment slows absorption but does not stop it, and is normally repeated every 1-2 years on the most used surfaces such as kitchen tops and bathrooms.
What not to do
Do not rub (it spreads the stain and scratches the stone, Mohs hardness 3-4), do not use vinegar, lemon, limescale remover, bleach or ammonia, and avoid abrasive sponges or kitchen degreasers: almost all are too aggressive for calcium carbonate.
When to stop
If after two poultices the stain has not changed, if it is rust or ink, or if the surface is already dull, stop trying: every further home attempt can make it worse. A restorer can re-hone or re-polish the area on site.
Absorbent poultice, step by step
- 01Blot at onceDab the liquid with paper towel or a microfibre cloth, without rubbing. The longer you wait, the deeper the stain goes.
- 02Wash with lukewarm water and neutral detergentUse a pH-neutral natural stone detergent, rinse with clean water and dry. Sometimes the stain is still superficial and this is enough.
- 03Prepare the poulticeUse an absorbent stone powder (sold as "marble poultice") or talc or kaolin, mixed with distilled water into a paste as thick as yoghurt. For oil stains follow the product instructions, which may call for a suitable solvent.
- 04Apply and coverSpread a 2-3 mm layer that extends 2-3 cm past the edges of the stain, cover with cling film taped down and poke 2-3 small air holes.
- 05Leave for 24-48 hoursRemove the film, let the poultice dry completely (it pulls the stain out as it dries), then lift it off with a plastic spatula without scratching.
- 06Rinse, dry and assessRinse with water, dry and look in daylight. You can repeat once or twice; if the stain does not change, call a restorer.
Frequently asked questions
- How do you remove a wine or coffee stain from marble?
- Blot at once, wash with lukewarm water and neutral detergent; if it remains, apply an absorbent poultice for 24-48 hours. Do not use bleach, vinegar or ammonia.
- Can baking soda be used on marble?
- Baking soda is mildly abrasive and can dull polished surfaces: if used at all, only as a poultice and tested on a hidden spot first. A natural-stone poultice is better.
- Does treated marble still stain?
- Yes, less and more slowly. The protective treatment buys time to react but does not make marble waterproof; it should be repeated every 1-2 years on the most used areas.
- When is a restorer needed?
- When the stain is deep, or from rust or ink, after two poultices without result, or if the surface has turned dull.
See also
