Marmi di Carrara, since 1956
Get a quote

Guides · Marmi di Carrara · 1956

Dull marble: why it happens and how to polish it

Updated · By Marmi di Carrara srl

The three most common causes

Acid etching: dull marks where lemon, vinegar, wine, tomato or a limescale remover has fallen. Wear: in walkways and on heavily used tops the polish wears away. Scratches: Mohs hardness is 3-4, so sand, metal objects and abrasive sponges leave micro-scratches that dull the surface.

What can be done at home

For a light mark on a small area you can use a consumer marble polishing powder following its instructions, on a clean dry surface, testing first in a hidden spot. Do not rub dry and do not insist: if the mark does not improve in two or three attempts, move to a professional.

What a professional does

A stone mason or restorer uses diamond discs of progressive grit and polishing powders to re-hone and then re-polish the surface directly in the home or on site. A scratched or etched surface can be restored: it is one of the advantages of natural marble.

Honed or polished: a choice that prevents

A honed (matt, silky) finish hides etching and wear far better than a polished one, and is often preferred for high-traffic floors and kitchen tops. If a reflective shine matters, factor it in: marks show more on polished stone.

Treating a light mark, step by step

  1. 01Clean and dryWash the area with lukewarm water and neutral stone detergent, rinse and dry with a microfibre cloth: dust or dirt will scratch during polishing.
  2. 02Test in a hidden spotApply the polishing product on a barely visible corner and check the result once dry before going on.
  3. 03Use a little product with a damp clothFollow the maker's instructions: normally a small amount of powder with a soft damp cloth, in light circular movements.
  4. 04Rinse and dryRemove every residue with clean water, dry and look in raking light to judge the result.
  5. 05Stop and call a professional if it does not improveAfter two or three attempts without improvement, or on large surfaces, have a stone mason re-hone and re-polish: this avoids halos and differences in shine.

Frequently asked questions

Why has my polished marble turned dull?
Almost always from acid etching (lemon, vinegar, limescale remover) or from wear and micro-scratches. The polish can be restored.
Can marble be re-polished at home?
Light marks on small areas yes, with a polishing powder and a prior test; large surfaces or deep marks need the professional, who re-polishes on site.
Polished or honed marble?
Honed hides etching and wear better and is recommended for floors and heavily used tops; polished is more brilliant but shows marks more.
Does a protective treatment prevent dulling?
It protects from stains but not from the chemical attack of acids, which act on the calcium carbonate of the marble itself.

See also

Request a quote

WhatsApp