Marmi di Carrara, since 1956
Get a quote

Marble products

Marble columns

The marble column is a vertical element with a circular or polygonal section, in a single piece or in stacked drums. It is chosen for lobbies, porticoes, churches and representative spaces, or as a decorative furnishing.

Request a quote

How to choose

Diameter and height depend on the function: a load-bearing column must be calculated by an engineer, a decorative one can be more slender. Compact stones with no fractures running lengthways are used. The shaft can be smooth, fluted or grooved, with a polished or honed finish.

Fabrication and installation

The shaft is made from a block on a lathe, then finished by hand for the fluting. The drums are joined with central steel pins and special mortars, and transport requires sturdy packaging.

Care and maintenance

Dust and wash with water and neutral soap. Knocks at the base should be prevented with guards where there is foot traffic.

Materials for columns

Frequently asked questions

Is the column always in a single piece?
Not always: above a certain height it is made in stacked drums, with internal pins, to make transport and installation easier. If well made, the joint is barely noticeable.
Can a load-bearing column be made in marble?
Yes, but a structural calculation is needed to establish the section and the permitted load. It is not decided by eye and must be entrusted to a designer.

From the quarry to your project

Request a quote

Sizes, photos or a drawing: we reply within one working day with photos of the available slabs.

WhatsApp